Advertisement
INSTALLATION
CONNECTION TO THE MAIN
SUPPLY
Warning: Electrical shock hazard!
!
Electrical installation must comply with
national and local codes.
Warning: This appliance must be
!
grounded!
Warning: Avoid fire hazard or electrical
!
shock. Do not use an adapter plug, an
extension cord, or remove grounding
prong from electrical power cord , have
a qualified electrician install an outlet
near the appliance. Failure to follow this
warning can cause serious injury, fire or
death.
Warning: Risk of Electric Shock or
!
Fire. Grounding through the neutral
conductor is prohibited for new branch
circuit installations (1996 NEC), mobile
homes, and recreational vehicles,
or in an area where local codes
prohibit grounding through the neutral
conductor.
• Before starting any work the electrical
installation, the electrical power to
the range must be shut off while line
connections are being made. Failure to
follow these instructions can result in
death, fire, or electrical shock.
Provide Electrical connection
• Install the junction box under the cabinet
and run 120/240 or 120/208 Volt, AC
wire from the main circuit panel. DO NOT
connect the wire to the circuit panel at
this time.
Provide Electrical connection
• This appliance must be supplied with
the proper voltage and frequency and
connected to an individual, properly
grounded branch circuit, protected by a
circuit breaker or fuse. A circuit breaker
or fuse is required by your appliance.
The circuit breaker or fuse amperage
recommended for your appliance is 40A
or 50A.
Observe all governing codes and local
ordinances
• A 3 wire or 4 wire single phase 120/240
or 120/208 Volt, 60 Hz AC only electrical
supply is required on a separate circuit
fused on both sides of the line (red and
black wires). A time-delay fuse or circuit
breaker is recommended. DO NOT fuse
neutral (white wire).
Caution: Wire sizes and connections
!
must conform with the fuse size and
rating of the appliance in accordance
with the American National Electrical
Code ANSI/ NFPA No. 70-latest edition.
Our company shall not held responsible
i
for any damage caused by using the
appliance without grounded receptacle.
Caution: This range must be electrically
!
grounded in accordance with local
codes, or in their absence, with the
National Electrical Code ANSI/NFPA
No. 70-latest edition in United States.
Installation should be made by a
licensed electrician.
Warning: Risk of electric shock,
!
short circuit or fire by damage
of the main power supply!
The main power supply lead must
not be clamped, bent or trapped or
come into contact with hot parts of
the appliance. If the main power cable
is damaged, it must be replaced by a
qualified electrician.
• This range may be connected by means
of permanent "hard wiring" (flexible
armored or nonmetallic shielded copper
or aluminum cable), or by means of a
power supply cord kit. Only a power
supply cord kit rated at 120/ 240 volts
and 40 or 50 amperes terminating in
tinned leads and marked for use with
ranges shall be used. If a 50 Amper cord
is used it must be marked for use with a
1 3/8 inches (35 mm) diameter opening.
19
Advertisement
