Husqvarna Z560X Operator's Manual page 4

Roll Over Protection Structure (ROPS)
ROPS is a protective frame that decreases the risk of
injury if the product overturns. Use the ROPS and the
safety belt when you operate the product on slopes.
Steering controls
The direction of the product is controlled by the 2 control
Product overview on page 3 . The control
levers. Refer to
levers can be moved forward and rearward from a
neutral position. Refer to
page 14 .
Operator Presence Control (OPC)
The OPC engages when the operator lifts from the seat.
The engine and the drive to the blades stop if the blades
are engaged or the parking brake is not applied. Refer to
Operation conditions on page 9 .
Ignition key
The ignition key has 4 positions:
• Start position (A)
• Run position (B)
• Headlight position (C)
• Stop position (D)
A
B
C
D
Headlights
A
B
C
D
• Turn the ignition key to the headlight position (C) to
operate the product with the headlights on.
4
To operate the product on
• Turn the ignition key to the run position (B) to
operate the product with the headlights off.
Throttle control
The throttle control adjusts the speed of the engine and
the speed of the blades if the blades are engaged. The
throttle control has 2 end positions, idle speed and full
throttle.
A A
• Idle speed (A) - decreases the engine speed.
• Full throttle (B) - increases the engine speed.
CAUTION:
at idle speed (A) for longer time than
necessary. Too much operation time at idle
speed can decrease the life of the spark
plugs.
PTO (Power Take-Off) button
The PTO button engages and disengages the PTO
clutch and the cutting deck or other equipment
connected to it. The correct start conditions must be
obeyed to engage the drive of the blades. Refer to
Operation conditions on page 9 for the correct start
conditions.
• Pull the PTO button out to engage the drive to the
blades or other equipment.
• Push the PTO button in to disengage the drive to the
blades or other equipment.
Fuel gauge
The fuel gauge shows the fuel level and will flash yellow
when the fuel level is approximately 1.0 gallons/3.8 l.
Product overview on page 3 for the position of
Refer to
the fuel gauge.
Do not operate the engine
2173 - 002 - 22.08.2023
B