Husqvarna Z560X Operator's Manual page 18

Maintenance
Do a check of and adjust the
8
valve clearance.
Clean the valve seating surface.
Replace the air cleaner secon-
10
dary element.
Do a check of the hydraulic oil
level.
Replace the hydraulic oil and fil-
11 12
ter. ,
To clean the product
CAUTION:
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass and dirt on and around the
transmission, the transmission air intake, and the
engine.
• Use running water from a hose to clean the product.
Do not use high-pressure.
• Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
• Use compressed air to clean the top side of the
mower deck.
• Use a water hose to clean below the cutting deck.
• When the product is clean, start the cutting deck for
a short period to remove remaining water.
To clean the engine and the muffler
Keep the engine and muffler free from grass cuttings
and dirt. Grass cuttings soaked in fuel or oil on the
engine can increase the fire risk and the risk that the
engine becomes too hot. Let the engine cool before it is
cleaned. Clean with water and a brush.
8
Must be done by approved service agent.
9
Must be done by approved service agent.
10
In conditions with dust, cleaning and replacement must be done more frequently.
11
Must be done by approved service agent.
12
In conditions with dust, cleaning and replacement must be done more frequently.
18
Daily maintenance
Before After
use use
9
X
Do not use a high-pressure
Maintenance interval in hours
25 50 100 250
Grass cuttings around the muffler dry quickly and are a
fire risk. Use a brush or remove the grass cuttings with
water when the muffler is cold.
To clean the battery
Corrosion and dirt on the battery and the terminals can
cause the power of the battery to decrease.
1. Remove the battery. Refer to
the battery on page 20 .
2. Flush the battery with water and let dry.
CAUTION:
pressure washer or a steam cleaner.
Water can go into bearings and electrical
connections and cause corrosion which
causes damage to the product.
3. Clean the terminals and the cable ends of the battery
cables with a wire brush.
To examine and adjust the parking
brake
Make sure that the adjustments are done equally on the
2 parking brakes of the product.
1. Park the product on level ground.
2. Stop the engine.
Each
season
300 400 500
*
*
O
*
To remove and install
Do not use a high-
2173 - 002 - 22.08.2023