Lorawan Setup - Siemens QNA2 D Series Commissioning

Indoor air quality multi-sensor

Hide thumbs Also See for QNA2 D Series:

Table of Contents

5 LoRaWAN setup

Proceed as follows:

●

Install the Hub in a central location (best possible reception).

●

If the quality of the LoRa signal is sufficient: Keep the original antenna on the hub. You can check signal

quality from the LoRaWAN using:

–

a field tester

–

the User Console (Software version is 5.6.2 or later.). Once the Hub and the LoRaWAN device are

paired, you can verify the

●

Where signal strength is too weak: remove the original antenna out of the cabinet; use an RF extension cord

with a SMA connector up to 2 meters + 1 adhesive support to hold the antenna.

●

Where signal strength is still too weak: use a high-gain antenna with a maximum 10-meter cable; this

antenna can, be used outside or on other floors to obtain the best signal quality.

Proceed as follows for each sensor:

1. Log in to user console (available at console) and go to Equipment.

2. Add multi-sensors by searching Siemens - IAQ-Multi-sensor from equipment list.

A6V13589457_en--_b

signal

quality.

LoRaWAN setup

13 | 16

Table of Contents