Table of Contents
Advertisement
Troubleshooting
Problem
Check
No power
Check the battery power
Check the polarity position
Not inflating
Check the cuff is plugged correctly
Check for tears or breaks of air plug
Possibly moved the arm during inflation
Err and Not working
Possible talking during measurement
Check if cuff is loose on arm
Cuff leaking
Check if cuff is broken / ripped
Please contact Medescan Customer Service team on 1300 736 330 for any queries or
unresolved issues.
SYMBOL DESCRIPTIONS
The following symbols may appear in this manual, on the Medescan Smart
Blood Pressure Monitor, or on it's accessories. Some of the symbols
represent standards and compliances associated with the Medescan Smart
Blood Pressure Monitor and its use.
Authorized Representative in the European Community
CE Mark: conforms to essential requirements of the Medical
Device Directive 93/42/EEC.
Date of manufacture.
Manufacturer
Specifies serial number
Type BF applied part
Direct current
DISPOSAL: Do not dispose this product as unsorted municipal
waste. Collection of such waste separately for special treatment
is necessary.
Follow instructions for use
14
Cause and solution
Replace the batteries
Install the batteries in the
correct position and polarity
Insert the cuff into the air
socket
Change to a new cuff
Please stay still
Please remain silent
Wrap cuff tightly
Change to new cuff
Face up
Fragile
Avoid water
Avoid direct sunlight
Class ll equipment
No Sterile requirements
Not category AP / APG equipment
Mode of operation: continuous
5.6. Memory
Each unit stores 120 sets measurements for 2 users, totally 240 memory sets
（User A and B）.
Viewing the stored values
With the unit off, press the Memory button. The display first shows "A", then
shows an average of all measurements stored in the unit. Please note:
Measurements for each user are averaged and stored separately. Be certain
that you are viewing the measurements for the correct user. Pressing the
Memory button again displays the previous value. To view a particular stored
memory, press and hold the Memory button to scroll to that stored reading.
5.7. Discontinuing a Measurement
If it is necessary to interrupt a blood pressure measurement for any reason
(e.g the patient feels unwell), the Start/Stop button can be pressed at any
time. The device then immediately lowers the cuff pressure automatically.
15
Advertisement
Table of Contents
