Using Your Monitor For The First Time - MedeScan BPS01 User Manual

4. Using your Monitor for the First Time

4.1 Using batteries for power
Battery Installation
Use only 1.5V "AA" alkaline batteries with this device.
1. Press the hook on the bottom of the battery cover and lift the cover off in
the direction of the arrow (Picture-04).
2. Install 3 "AA" size batteries and make sure the + (positive) and - (negative)
polarities match the polarities of the battery compartment, then close the
battery cover. Make sure that the battery cover is securely in position.
Picture-04
Battery replacement
1.When the Low Battery Indicator appears on the display, turn the monitor off
and remove all the batteries. Replace with 3 new batteries at the same time.
Long-life alkaline batteries are recommended.
2.To prevent the damage of monitor from leaked battery fluid, please take the
batteries out of the monitor if it will be unused for a long time (generally
more than 3 months). If battery fluid get in your eyes, immediately rinse with
plenty of clean water. Contact a physician immediately.
3. Dispose of the device, components and optional accessories according to
applicable local regulations. Unlawful disposal may cause environmental
pollution.
8
4.2. System Settings
After you load the battery or connect power for the monitor,long press the
SET button for more than 3s, and then you can start to set.
Setting the Year:
When the year display is flashing, press the MEM button continuously and the
year will increase by 1 until 2099, and then return the initial year (2020).
Once the desired year is reached, press SET button to confirm.
Setting Month / Day:
Initial Month/Date is 1/01, when the Month display is flashing, press the MEM
button, and the month will increase by 1 with each press. Once the desired
month is reached, press SET button to confirm.
With the day is flashing, press the MEM button, the day will increase by 1 with
each press. Once the desired day is reached, press SET to confirm.
Setting Time :
When the hour display is flashing, press the MEM button, and the hour will
increase 1 with each press. Press SET button to confirm desired hour.
When the minute display is flashing, press the MEM button, and the minutes
will increase 1 with each press. Press SET button to confirm desired minute.
Setting the User:
Press the MEM button to select User A or User B. When display A (/B) on the
screen, press the MEM button to switch to user B (/A). Press the SET button
to confirm.
Record Delete:
When you checking the memory data, long press MEM button to delete
existing user measurement data.
Note:
You can't delete all measurement record from the monitor storage at one
time, if you decide to delete the all record, please keep the record in another
way, in case you need it some days later. Take the battery out won't lead to a
record missing.
9