Siemens MAMMOMAT 3000 Opdima Service Instructions Manual page 32

The interactive firmware monitor commands provide a user command interface. The mon-
itor will display the OK prompt when it is ready for input.
Select the new command mode by entering
Entering the
Entering the
Entering the
Entering the
Entering the
value.
Entering the
Entering the
Entering the
category.
The
The
The
Entering the
Entering the
To detect a faulty device enter
ok probe-scsi
Fig. 2 Test of the SCSI bus
The system should show all the drives connected to the bus:
MAMMOMAT 3000 Opdima
Service
command boots the default boot device.
command displays a list of all device tree nodes.
command displays a list of all device aliases.
command displays the predefined values of the NVRAM.
command sets the values to the default values.
command displays the available test categories and subcategories.
command gives you information about
command tests all devices below the root node.
command tests the on-board SCSI bus.
command tests all installed SCSI buses.
command returns the display to the boot prompt.
command performs a reboot.
Register 5 SPB7-230.061.02
Rev. 02
command changes the selected variable to the new
Page 2 of 10
05.99 SPS-UD
3
3
category or sub-
Siemens-Elema AB
Solna, Sweden