Follow all general safety guidelines when replacing the Camera Interface D100.
Note the special safety guidelines indicated in these instructions.
Fig. 11 Card retainers
Siemens-Elema AB
Solna, Sweden
Register 5
SPB7-230.061.02
Rev. 02
•
Open the top cover of the box (refer
to chapter 1).
•
Locate the Camera Interface D100
(refer to Fig. 10).
•
If there is a PCMCIA board
installed, remove the PCMCIA
interface (refer to chapter
"Removing the PCMCIA Board").
•
Open the SBUS card retainers.
•
Lift the card from its position.
Carefully lift the corners of the D100
to release it from the connector
•
Remove the board and place it on
'
the grounded tabletop pad.
3
2
Page 13 of 20
05.99
SPS-UD
MAMMOMAT 3000 Opdima
Service
2
2