Whirlpool Pro-Style Manual page 6

Convert Gas Pressure Regulator
1. Locate the gas pressure regulator at the left rear
of the range.
A
A. Gas pressure regulator
2. Remove the gas pressure regulator cap by using a
large flat-blade screwdriver, turning the regulator cap
counterclockwise.
NOTE: Do not remove the spring beneath the cap.
3. Turn over the gas pressure regulator cap, and reinstall
on the regulator so that the hollow end faces out and
the letters "LP" are visible.
4. Tighten the gas pressure regulator cap by using a large
flat-blade screwdriver, turning the regulator cap clockwise.
5. Test the gas pressure regulator and gas supply line.
The regulator must be checked at a minimum 1" (2.5 cm)
water column above the set pressure. The inlet pressure
to the regulator should be as follows for operation and
checking the regulator setting:
LP Gas:
Minimum pressure 11" (27.9 cm) WCP
Maximum pressure 14" (35.5 cm) WCP
6
Gas Supply Pressure Testing
Gas supply pressure for testing regulator must be at least
1" water column pressure above the manifold pressure
shown on the model/serial rating plate.
Line pressure testing above ½ psi gauge (14" WCP)
The range and its individual shut-off valve must be
disconnected from the gas supply piping system during
any pressure testing of that system at test pressures
in excess of ½ psi (3.5 kPa).
Line pressure testing at ½ psi gauge (14" WCP)
or lower
The range must be isolated from the gas supply piping
system by closing its individual manual shut-off valve during
any pressure testing of the gas supply piping system at test
pressures equal to or less than ½ psi (3.5 kPa).
Convert Oven Bake Burner (30" [76.2 cm] and
36" [91.4 cm] models and the right oven cavity
on 48" [121.9 cm] models)
1. Slide the bake burner cover to the right or left.
A
A. Bake burner cover
2. Lift up and remove oven bake burner cover, and set aside.
3. Using a 7 mm nut driver, unscrew oven baffle nuts and
remove oven baffle. Set aside.
A. Oven baffle
B. Oven baffle nuts
A
B