Table of Contents
Advertisement
@LENS connector (12-pin)
Connect a lens cable.
@VTR START button
When the CCU-700/700P Camera Control Unit is
connected to the CCU-700 connector, a return
video 2 signal is monitored on a viewfinder screen,
and intercom audio is sent to the CCU-700/700P
from the microphone of the headset by setting the
internal switch.
For details, refer to the System Manual.
When a VTR is connected to the camera using the
CA-753/753P, pressing this button starts recording,
and pressing again stops recording. It is the same
function as with the VTR button on the lens.
© SHUTTER switch
OFF:
An electronic shutter does not function.
ON:
An electronic shutter is activated.
SEL: The shutter speed and shutter mode change
each time the switch is set to this position.
For details, refer to the System Manual.
OQAUTO W2B BAL (automatic white balance/
black balance adjustment) switch
Adjusts the white balance and black balance
automatically.
WHT:
The white balance is automatically
adjusted. When the WHITE switch on the side
of the camera is set to A or B, the adjusted
value is stored in memory A or B.
BLK:
The black balance is automatically
adjusted. The black set is simultaneously
adjusted.
The SHUTTER and AUTO W/B BAL switches do
not function when the camera is connected to the
CCU-700/700P.
© Back tally lamp
Lights when a red tally signal is supplied. When
the CALL button on the MSU-700 or RCP-700-
series unit is pressed, the lamp lights if not lit, and
goes out if lit.
When a VTR is connected to the camera using the
CA-753/753P, the lamp lights when a rec tally
signal is supplied from the VTR.
@ Back tally lamp switch
Selects whether to light the back tally lamp when
the red tally signal is supplied.
ON: The back tally lamp lights.
OFF: The back tally lamp does not light.
@CALL button
Press to call the operator of the CCU-700/700P
Camera Control Unit, MSU-700 Master Setup Unit
or RCP-700-series Remote Control Panel. When
the CALL button is pressed, the red tally lamp on
the CCU-700/700P lights if not lit, and goes out if
lit, and the CALL button on the MSU-700 and
RCP-700-series unit lights and a buzzer sounds.
ORET 1 (return video 1) button
Press to monitor the return video | signal on the
viewfinder screen. When the MONITOR OUT
switch on the EN board is set to VF, the
MONITOR connector also outputs the return
video | signal.
ORET 2 (return video 2) button
Press this button when another return video system
(return video 2) is used. Then the return video 2
signal can be monitored on the viewfinder screen.
When the MONITOR OUT switch on the EN
board is set to VF, the MONITOR connector also
outputs the return video 2 signal.
@ INCOM 1, INCOM 2 (intercom 1, 2)
connectors (XLR 5-pin)
Connect an XLR 5-pin-type headset. The INCOM 1
connector can be used for communication even if the
power to the camera is turned off on the CCU-700/
700P.
@ INCOM 1, 2 PROD/ENG (intercom 1, 2
producer/engineer line select) switches (for
the BVP-750)
Select the destination for the intercom 1 or 2
signals between the producer line and engineer
line.
PROD:
Goes to the producer line.
ENG:
Goes to the engineer line.
@ PGM (program audio signal level) controls
(for the BVP-750)
Adjust the output level of the program audio.
9
Advertisement
Table of Contents
