AEG LFR9514L6U User Manual page 20

7.7 Finish In
Set this option as last after programme
and other options selection, otherwise it
can be cancelled if you change some
setting.
This button allows activating the Finish In
option and by means of the Plus (+
increases) and Minus (- decreases) touch
buttons it is possible to choose the time within
which a programme should terminate. The
programme end can be postponed by one 1
hour every + button touch until 24 hours
maximum. The 'finish in' time can be reduce
by means of the - button until 0.
The display shows the normal programme
duration alternatively with the set programme
end time (expressed in hours 0h). The
minimum selectable time corresponds to
rounded up hour of the maximum duration of
a programme (e.g. if the cycle duration lasts
3:15 hours, the minimum selectable time will
be 4h).
After programme start, the door is locked and
the appliance starts the ProSense phase.
When load estimation ends, on the display
the icon of running phase blinks and the time
digit counts down in steps of one hour and in
steps of 1 minute during the last hour.
7.8 Start/Pause
Touch the Start/Pause
pause the appliance or interrupt a running
programme.
7.9 Plus Steam
This option adds a steam phase followed by a
short anti-crease phase at the end of the
washing programme.
The steam phase reduces fabric creasing and
facilitates the fabric ironing.
The Plus Steam option achieves good results
with a small load because steam better
penetrates the laundry if there is more space.
For this reason, the programme maximum
load combined with this option is 2 kg
(approximately 8 - 10 shirts).
20 ENGLISH
button to start,
When setting the Plus Steam option, the
maximum load drops to 2 kg in the display
and programme time is adjusted accordingly.
The indicator blinks in the display during
steam phase.
This option can affect the programme
duration.
When the programme stops the display
shows a zero , the indicator
on.
The anti-crease phase starts, the indicator
is blinking, and the Start/Pause
remains lit. The drum performs smooth
movements for about 30 minutes to keep the
steam benefit.
To interrupt the anti-crease phase, you can:
• Press the On/Off
seconds to activate or the deactivate the
appliance.
• Turning the programme dial in another
position.
When the anti-crease movements stop and
the door unlocks, the appliance proposes
again the previous set programme.
A small laundry load helps to reach better
results.
7.10 Extra Rinse
With this option you can add a few rinses to
the selected washing programmes and
optimise the fabric softener distribution and
improve the fabric softness.
It is suggested when you use the fabric
softener.
Useful for people allergic to detergents and in
areas where the water is soft.
This option increases the programme
duration.
The button indicator comes on.
is steady
led
button for a few