System Failure" Page - Telestar EC 311 S Installation Manual

EVSEMaster
Periodic charging in custom charging refers to se�ng the cyclic charging parameters. When it is �me to charge, the charging sta�on
does not have other charging and the charging gun is plugged in, and the charging sta�on will automa�cally start charging, which is like
a mobile phone alarm clock. When the �me is up, it will be charged automa�cally, and it can be used always for one se�ng.
The cycle charging in the custom charging is as shown in the figure above. Below steps are mainly required, and one step corresponds to
one picture to proceed in sequence.
1. Select the charging �me and the charging power.
2. Select the �med hour.
3. Select the �med minute.
4. Select the repe��on cycle.
5. Select the bu�on enabled to set. If the se�ng is successful, there will be a success prompt.
6. Select the "Prohibit" bu�on to cancel the periodic charging func�on. If the cancella�on is successful, there will be a success prompt.

4.14 "System failure" page

When the charging sta�on is faulty, the homepage will display system fault informa�on which includes: Low Voltage, Over Voltage,
Over Current, Short Circuit, Over Temperature, CP Error, etc.
Figure 23 Main faults page
EVSE Master APP User Manual
16