Overview; The Name Of The Charging Sta�On And The Bluetooth; App Installa�On Page; Quick Installa�On Instruc�On - Telestar EC 311 S Installation Manual

EVSEMaster
1

Overview

EVSE Master APP is a mobile phone APP for smart charging sta�on, which is divided into Android and iOS versions.
This APP is connected to the charging sta�on via Bluetooth on mobile phone or WIFI for data interac�on.
Its main func�on is to monitor the status of the charging sta�on, control the start and stop of the charging sta�on for charging, set the
charging mode, check and count the charging records, and upgrade the firmware wirelessly.
The APP uses Bluetooth on mobile phone or WIFI LAN for data communica�on. The communica�on method is to connect through the
Bluetooth channel for the first �me, and a�er se�ng the WIFI communica�on parameters, the WIFI channel communica�on is
performed. When both communica�ons are valid, the APP automa�cally switches to WIFI priority.
Note on communica�on distance. Bluetooth communica�on is a point-to-point communica�on between the mobile phone and the
Bluetooth module of the charging sta�on, and its effec�ve distance is about 10 meters in an open field; WIFI communica�on is to make
the mobile phone and the charging sta�on connected to the same WIFI router, and its effec�ve distance is determined by the signal
distance of the WIFI router, under the condi�on that both the charging sta�on and the mobile phone are within the signal range of the
WIFI router. No ma�er which method exceeds the communica�on distance, the charging sta�on cannot be operated.
2
The name of the charging station and the Bluetooth
The name of the charging sta�on is composed by "ACP#EVSEXXXX", that is, the prefix "EVSE" plus the last 4 digits of the charging
sta�on number, such as EVSE1234.
The name of the Bluetooth module that comes with the charging sta�on is "ACP#EVSEXXXX", that is, the prefix "ACP#" plus "the name of
the charging sta�on", such as ACP#EVSE1234.
The default name of the charging sta�on at the factory is "EVSEXXXX", which is displayed at the top of the APP homepage, indica�ng
which charging sta�on is currently connected, as well as shown in the upper le� corner of the charging sta�on display. If the two names
are inconsistent, they should be modified again through the page "System Se�ngs-General Se�ngs-sta�on Name" below.
The default name of Bluetooth module of the charging sta�on is "ACP#EVSEXXXX" at the factory, which is shown when searching for
available charging sta�ons below, such as ACP#EVSE1234.
When modifying the name of the charging sta�on below, the corresponding places will also be modified.
3
APP installation page
3
.1 Quick installa�on instruc�on
Download the APP so�ware from the official website and install it. The quick installa�on instruc�on is as follows:
EVSE Master APP User Manual
Figure 1 APP installa�on page
01