Start-Up And Testing - DEFENDERTECH DT-800 Lan Turbo Installation And Maintenance Manual

Fog generator
Hide thumbs Also See for DT-800 Lan Turbo:
Table of Contents

Advertisement

Available languages

Available languages

START-UP AND TESTING

It is possible to test the machine independently from a connection to an alarm control panel by
acting directly on the ARM and FOG terminals
It is possible to freely test the system using "drinking water" instead of the liquid with which the
fog is produced, from the appliance will come out a dry and transparent but "noisy" steam (at
the end of this operation remember to restore the liquid level to the 100% acting on DipSwitch
nr.4).
TECHNICAL INSTALLATION
• Once the machine is connected to the mains, activate the backup battery, connecting the
"flying" cable to the respective free terminal.
• Make sure that the whole DIPSWITCHES are properly set (see table on page 13).
• Give 220V power to the appliance
• ARM the appliance through "ARM" (see page 11), when it will be ready it will emit a BEEP of 3 "
• Operate the shot using "FOG" (see page 11)
To interrupt the "shot and pause" cycle, the device must be disarmed by opening the contact on
ARM.
20

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DT-800 Lan Turbo and is the answer not in the manual?

Table of Contents