DEFENDERTECH DT-800 Lan Turbo Installation And Maintenance Manual page 60

ETHERNET NETWORK CONNECTIVITY:
The DT-x00Lan series devices have been designed to be monitored and programmed remotely using the
DEFENDERTECH "DT-FogControl" and "DT-MultiFogControl" software.
DT-FogControl is responsible for programming:

The IP address, port,

Date and time

Setting the block time slot

Automatic Activation Timer, daily, weekly and for Negligence

Download the technical event log

Liquid Level Reset

Fault signal reset (Note: if the fault is persistent, the signal will continue)

Perform the "shot" (if there are the necessary technical conditions)

Changing the passwords of the 3 levels of access
The default IP address is 192.168.1.99 port 502.
DT-FogControl also allows you to check the status of the device and the wire inputs, as well as the basic
and special programming set physically through the DipSwitches.
DT-MultiFogControl is responsible for monitoring simultaneously the operating status of several Fogs
Generators (even in different geographical sites).
Both software can be requested for free by making a request (complete
IP ADDRESS AND PASSWORD RESET PROCEDURE
1. Disconnect ARM and FOG
2. Switch the appliance off completely
3. Note down the DIP-SWITCH configuration
4. Turn all DIP-SWITCH OFF
5. Remove the Jumper from BUZZ (J3)
6. Place the Jumper on J2
7. Set the DIP-SWITCH No. 10 to ON
8. Supply the appliance
9. Set the DIP-SWITCH no. 1 to ON
10. Switch the appliance off again
11. Remove the Jumper from J2 and replace it on BUZZ (J3)
12. Restore the DIP-SWITCH as noted down before (point 3)
13. Supply the appliance
Gateway and SubNet
with social data) at the following address
info@defendertech.eu
18