Advertisement
SE
FIN FEY
MOUNTING THE RACK MOUNTING
ADAPTORS (Applicable 5/G model only)
If you mount the accessory rack mount adaptor
onto the RG-2, you will be able to install the RG-2
into a rack designed to meet EIA standards (ikke
the Pioneer JA-R2S) with a 2 unit mounting piteh.
Mounting Procedure
1. Detach the,rubber bushes from both sides of the
RG-2,
2,Secure the rack mount adaptors onto the side
pancls with the accessory mounting scrows
(MAx10}. (Fig. 8)
Rack Mounting
1, Remove the rubber fect (4) from the RG.2,
using a Phillips serowdriver (this is not necessary
if you leave a gap between the components).
2, Insort the RG-2 and align with the BLA standard
mounting holes (mounting pitch: 2U).
8, Serew the RG-2 into place using the accessory
oval countersunk serews (M5x16), angular
washers and plastic rings (four of each) and a
Phillips screwdriver.
Nore:
The reck mount adeptors are $ mm thick. When aligning
them with other Pioneer stereo components with 2 thick
ness of § mm, slide the accessors spacers behind the
'adapters and then attach (Fig, 9)
Flack mount asepter.
a Py ~
eee
ao
= Mounting stew
Fig. 8
Plastic ino
aG2
Fig. 9
List of Parts for Rack Mount Adaptor
Mounting screws (M4x10); 4, Oval countersunk
serews (MBX16); 4, Angular washers; 4, Plastic
rings; 4, Spacers (t: 2mm); 4,
PIONEER ELECTRONIC CORPORATION
ONEER ELECTRONICS AUSTHALIA PTY. LIE. 1
«<p0A03§509
4-1,.Meguro
7-Gnome, tvaguro-ku, Tokyo. 153. vepan
Printed
in Japan (ARE-3230)
Advertisement
