Advertisement
4. Unit may need to be flushed.
Add warm tap water to both the clean water tank and the solution tank. Make sure both tanks
are seated firmly, clean any debris from the distributor bar and turn the unit ON, recline the
handle. Push the unit forward continuously about 3-4 times or until water comes out of the
bottom again.
5.
Unit may need to be reset.
To reset SmartWash, unplug it from the wall. Remove the nozzle cover and take out the
brushes. Now, replace the nozzle cover, plug the unit back in, and cycle the power on and off
4 times. Replace the brushes and test to see if the reset worked.
C. Accessory Hose/Tool Won't Dispense
1. Check to ensure that Clean Water Tank and Solution Tanks are full.
2. Ensure there are no clogs in the hose end.
(1) Check both ends of the hose and clean any clogs or debirs you may enocunter.
(2) Insert a small object into the hose solution port to ensure is not clogged.
Advertisement
