Table of Contents
Advertisement
en Installation instructions
Ensure that an opening at the top of the rear of the
2.
unit is unobstructed.
If the clearance from the back wall of the unit is less
3.
than 20 mm, create an opening on the underside.
Do not hermetically seal the lower base.
4.
Note: If the appliance is installed in an island unit or in
another location that is not described here, guarantee
that the hob is ventilated appropriately.
Installation above a drawer
¡ In order to guarantee good ventilation, the clearance
between the surface of the worktop and the upper
area of the drawer must be 65 mm.
Installation on built-in units
¡ In order to guarantee good ventilation, the clearance
between the surface of the worktop and the upper
area of the unit must be 100 mm.
16
20.6 Included in delivery
After unpacking all parts, check for any damage in
transit and completeness of the delivery.
Name
Induction hob
Instructions for installation and use
Attaching spacers
20.7 Installing the appliance
Select any side of the induction hob, and snap the
1.
installation shrapnel into the slot on the side.
Lift the hob horizontally and slowly place it into the
2.
opening in the worktop until the edge of the hob is
fully in contact with the worktop.
20.8 Connecting the appliance to the
electricity supply
Insert the mains plug of the appliance's power cable
1.
in a socket nearby.
Check the mains plug is inserted properly.
2.
a The appliance is now ready for use.
20.9 Installation and connection
See the nameplate (bottom of induction hob) for rated
voltage.
For EH8P5263HK:
¡ Make sure the electrical circuit, socket and fuse at
user's house complied with required 13A electrical
installation.
¡ Connect the socket properly.
Amount
1 unit
1 copy
1 set
Advertisement
Table of Contents
