Table of Contents
Advertisement
en Energy consumption display
Display
1
Factory setting
13.2 To access the basic settings:
Touch
. Switch on the hob.
1.
14 Energy consumption display
This function indicates the total amount of energy con-
sumed between switching the hob on and switching it
off again.
Once switched off, the energy consumption is dis-
played in kilowatt hours, e.g. 1.08 kWh, for
10 seconds.
15 Cookware test
This function can be used to check the speed and
quality of the cooking process depending on the cook-
ware.
The result is a reference value and depends on the
properties of the cookware and the cooking zone being
used.
15.1 Cookware detection
1.
Place the cookware at room temperature with small
amount of water, correctly positioned on the most
suitable cooking zone for the diameter of the bottom
of the cookware.
Go to basic settings and select .
2.
a Cookware detection activates， flashes.
a After 10 seconds the result will appear on the cook-
ing zone's display.
16 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
16.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, the online shop or a
retailer.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Never use unsuitable cleaning products.
▶
Do not use cleaning products while the hob is still
▶
hot. This may cause marks on the surface.
12
Function
Cookware test, result
Not suitable.
Not optimal.
Suitable.
Restoring factory set-
tings
1
Individual settings.
Factory settings.
Within the next 10 seconds, touch and hold
2.
seconds.
a Audible sounds, timer display
Touch
3.
。
a Left cooking zone indicator alternately flashes
Touch
repeatedly until the required function is dis-
4.
played.
Select the required setting from the setting area.
5.
a The indicator light shows the corresponding setting
value.
Touch and hold
until audible sounds.
6.
a The setting is saved.
Note: If you touch
during setting to leave, then the
new setting will not be saved.
The accuracy of the display depends on various factors
such as the voltage quality of the power supply.
The display can be activated in the basic settings.
→ Page 11
15.2 Detection result
Check the result using the following table.
▶
Display
Results
The cookware is not suitable for
the cooking zone and will therefore
not heat up.
The cookware will be heated more
slowly than expected and the res-
ult of the cooking process will not
be optimal.
The cookware is heating up cor-
rectly and the cooking process is
going well.
Unsuitable cleaning products
¡ Undiluted detergent
¡ Detergent intended for dishwashers
¡ Abrasive cleaners
¡ Aggressive cleaning products such as oven spray
or stain remover
¡ Abrasive sponges
¡ High-pressure or steam jet cleaners
16.2 Cleaning ceramic glass
Clean the hob after every use to stop cooking residues
from getting burnt on.
Note: Note the information on unsuitable cleaning
products. → Page 12
for 5
.
/
.
Advertisement
Table of Contents
