Table of Contents
Advertisement
AS-i A/B slave
The AS-i A/B slave can either be placed at an AS-i address in the A or B area. The
B area can be used only when no AS-i standard slave is placed in the A area.
As an option, startup
parameters can be permitted
here;
Whether this parameter can
be used depends on the
slave type.
Only 3 bits are available for
A/B slaves!
Bit 4 is required for the
address switchover.
Depending on the I/O
configuration, you can specify
the address range for
input(/output data here.
DP/AS-Interface Link 20E
Release 08/2008
C79000-G8976-C235−01
Technical description, installation instructions, operation
The parameters in this area specify
the slave profile.
As well as the I/O configuration:
S
S
If A/B slaves were placed in a B row,
the "(8)" for example becomes a "0"
since the highest bit is not set due to
the address distinction (A or B row).
ID code: standardized meaning;
ID1/2 code: expanded ID code:
standardized meaning.
39
Advertisement
Table of Contents
