HOMCOM 824-049V80 Assembly & Instruction Manual page 6

shown in Fig 3) or by your remote control (shown in Fig 2).
1. Place the FAN on a stable flat surface. Plug the cord set into a 120V~
electrical outlet. Plug on the FAN, existing room temperature will be
displayed at display panel.
2. POWER
the FAN off by pressing the 'POWER' button again.
3. SPEED
medium, or high by pressing 'SPEED'. The speed setting is displayed on
the LED screen (shown in Fig 4).
4. MODE
NATURAL, and SLEEP mode.
AL Mode
- NORM
- NATURAL Mode
speed(5s)→high speed(5s)→medium speed(5s), it works as per this
recycle.
- SLEEP Mode
high speed at 30 mins, then transfer to medium speed at 30 mins and
transfer to low speed until fan stop working. 2 ） If you set the mode at
medium speed, fan will work at medium speed at 30 mins, then transfer to
low speed until fan stop working. 3） If you set the mode at low speed, fan will
work at low speed until fan stop working. The LED Display will turn off if you
don't control the fan in 30 seconds, touch any button to turn on the display.
5. TIMER
length of operation from 1 hour to 12 hours.The LED Display will turn off if
you don't control the fan in 30 seconds, touch any button to turn on the
: Turn the FAN on by pressing the 'POWER' button; Turn
: You can adjust the fan speed to the desired level: low,
: Pressing the 'MODE' button will set the FAN into NORMAL,
:
Fan will start work at any speed you set up.
:
Fan will start work at low speed(5s)→medium
:
1）If you set the mode at high speed, fan will work at
: The fan is equipped with a timer that allows you to set it's
5