Table of Contents
Advertisement
3 Seeking the Selected Program Type
Press the <4 or ®{ button to make a seek of frequencies
with your selected type of program.
The display blinks and the seek starts.
lf your selected type of program is found, the name or the
frequency of the station is displayed and the station is tuned
into.
.
;
;
"PTY," blinks in the display for about 30 seconds.
If you make no key input in 30 seconds, the PTY selection
mode will turn off automatically.
:
lf no program can be found, "NO PTY' is displayed.
If you want to select another type of program, repeat steps 2 and
3 above.
Switching to Other Stations with the Same Type of Program:
' When "PTY" is blinking in the display, perform auto seek
tuning.
The tuner scans for another station with the same type of
program.
Canceling Program Type Function During Its Operation:
Press the mtt(PTY) button.
Confirming Program Type:
Press the DISP button.
The program type of the station currently tuned to will be
displayed for five seconds. During that time, "E" will blink in the
display.
If you tune to frequencies for which no program type has been
stored, "NO ENTRY" will be displayed.
To register a station as a program type:
Tune your radio to the station that you want to register as the
program type.
'2 Press the ® (PTY) button to enter the program type selection
mode.
i
Press the DISP button for at least two seconds.
The station will be registered as a program type, allowing it to
be the target of frequency seeks just as RBDS stations are.
You can store up to 48 stations.
17
Advertisement
Table of Contents
