KRC-708/888/X858/PS988R MICROCOMPUTER TERMINAL DESCRIPTION UPD784217GC103(105) (IC1: X14-618X-XX) System MicroComputer Pin Name Signal Name Purpose Operation Description P120/RTP0 CHCON Changer control terminal. ON:Hi, OFF:Lo P121/RTP1 CH_MUTE Muting input to changer. ON:Hi, OFF:Lo P122/RTP2 REQH Handshake request to changer. P123/RTP3 DIMMER Small detection. DIMMER ON:Lo, OFF:Hi Cassette mechanism main motor P124/RTP4...
Page 4
KRC-708/888/X858/PS988R MICROCOMPUTER TERMINAL DESCRIPTION UPD784217GC103(105) (IC1: X14-618X-XX) System MicroComputer Pin Name Signal Name Purpose Operation Description 52 P84/A4 WIDE K2I Forced Wide output. H:Forced Wide 53 P85/A5 NARROW I/O K2I Forced Narrow output. H:Forced Narrow During reception: Hi 54 P86/A6 Noise detection time constant SW /During search: Lo.
E2PROM replacement during servicing (Note) Similarly to the '98 models, leaving the set for more (KRC-888 only) than 30 minutes without writing the code causes an 1. Enter the test mode (see "(1) How to enter the test error and turns power off.
Page 6
KRC-708/888/X858/PS988R TEST MODE (12.2) Procedure for canceling the MASK key (13) Other request (when the set is reset or the back-up o Automatic panel closing when the TAPE/CD/MD is power is turned off while the MASK key is inserted is disabled. enabled) o Pressing the ATT key ON/OFF opens or closes the 1.
Page 7
KRC-708/888/X858/PS988R ADJUSTMENT Set the controls and switches as follows. BALANCE :center position BASS :center position LOUD :OFF DOLBY NR :OFF FADER :center position TREBLE :center position TUNER OUTPUT ALIGNMENT ITEM INPUT SETTINGS (RECEIVER) ALIGN FOR FIG. SETTINGS POINTS SETTINGS FM SECTION SEPARATION 98.1MHz TEST MODE:ON...
Page 8
PC BOARD (Component side view) (Foil side view) X13-9720-10 (J74-0984-12) X13-9720-10 (J74-0984-12) ILL+B ILL+B L CLK L CLK L DATAL L DATAL REMO REMO DGND DGND DIMMER DIMMER LOCK SW LOCK SW RESET RESET ILL G ILL G Refer to the schematic diagram for the value of resistors and capacitors.
Page 12
0-21 UPD784218GC105 TC7662BEOA 4.7uH KRC-X858 0-11 UPD784217GC103 ICL7660SIBA rating fuse(s). To reduce the risk of electric shock, RF GND KRC-888 0-22 UPD784217GC103 leakage-current or resistance measurements shall be FM ANT IN KRC-708 0-12 UPD784217GC103 R166 Q87,89 carried out (exposed parts are acceptably insulated FM+B R305 2.2K...
Page 13
GND LINE MODEL NAME UNIT No. IC2 : LC75878W DTC114EK 2SD1819A B LINE IC3 : RS-171 KRC-X858 DTC114TK 2SD2114K KRC-708 Q1,2 : DTA114EK or KRC-888 0-10 B38-1034 DTC114YK UN2111 KRC-778R Q3,4 : 2SD2114K KRC-778RY DTC114YUA Q5-7 : KRC107S KRC-PS988R 5.0V...
Page 14
AUTO NEWS B NR LOUD disc ED1 SEGMENT (B38-1034-05) (B38-1036-05) AUTO NEWS B NR disc LOUD ED1 COMMON (B38-1034-05) (B38-1036-05) CAUTION: For continued safety, replace safety critical components only with manufacturer's recommended parts (refer to parts list). indicates safety critical components. For continued protection against risk of fire, replace only with same type and rating fuse(s).
PAN HEAD TAPTITE SCREW N38-2030-45 PAN HEAD MACHIN SCREW D13-1453-14 GEAR ASSY D13-1312-34 GEAR N09-4184-05 MACHINE SCREW (M2X2) K : KRC-X858 K1 : KRC-708 E: Europe K: North America M: Other Areas M1 : KRC-PS988R indicates safety critical components. M2 : KRC-888...
Page 18
16WV KK1M2 RK73FB2A222J CHIP R 2.2K 1/10W M1 RK73FB2A223J CHIP R 1/10W C90-2926-05 ELECTRO 220UF 16WV K : KRC-X858 K1 : KRC-708 E: Europe K: North America M: Other Areas M1 : KRC-PS988R indicates safety critical components. M2 : KRC-888...
Page 19
MULTI-COMP 4.7K X4 C191 CK73FB1H103K CHIP C 0.010UF R90-0737-05 MULTI-COMP 100K X2 C201 CK73FB1H822K CHIP C 8200PF K : KRC-X858 K1 : KRC-708 E: Europe K: North America M: Other Areas M1 : KRC-PS988R indicates safety critical components. M2 : KRC-888...
Page 20
CHIP R 1/10W K1 R113 RK73EB2B752J CHIP R 7.5K 1/8W R252 RK73FB2A473J CHIP R 1/10W KM1 K : KRC-X858 K1 : KRC-708 E: Europe K: North America M: Other Areas M1 : KRC-PS988R indicates safety critical components. M2 : KRC-888...
Page 21
DIODE R339-342 RK73EB2B102J CHIP R 1.0K 1/8W R32-0229-05 SEMI FIXED VARIABLE RESISTOR M1 HZM4.7N(B2) ZENER DIODE K : KRC-X858 K1 : KRC-708 E: Europe K: North America M: Other Areas M1 : KRC-PS988R indicates safety critical components. M2 : KRC-888...
Page 22
DOLBY NOISE REDUCTION UNIT (X87-301X-XX) KRC104S TRANSISTOR UN2213 DIGITAL TRANSISTOR C1 -4 CK73FB1H471K CHIP C 470PF K K : KRC-X858 K1 : KRC-708 E: Europe K: North America M: Other Areas M1 : KRC-PS988R indicates safety critical components. M2 : KRC-888...
Page 23
D10-4375-08 SLIDER(MAIN PLATE) D13-1494-08 GEAR(B) D13-1495-08 GEAR(C) D13-1496-08 GEAR(D) D10-4376-08 ARM(P-G PLATE) J90-0948-08 GUID D15-0919-08 PULLEY(MID) K : KRC-X858 K1 : KRC-708 E: Europe K: North America M: Other Areas M1 : KRC-PS988R indicates safety critical components. M2 : KRC-888...
KRC-708/888/X858/PS988R SPECIFICATIONS KRC-PS988R Frequency Range 87.5MHz~108.0MHz (Frequency Step) (50kHz) Channel Space Selection FIX Usable Sensitivity 9.3dBf S/N 30dB (0.8µV/75Ω) Quieting Sensitivity 15.2dBf S/N 50dB (1.6µV/75Ω) Frequency Response 30Hz~15kHz (±3.0dB) S/N(dB) 70dB (MONO) Selectivity 80dB (±400kHz) Stereo Separation 40dB (1kHz) Frequency Range(kHz) 153kHz~1611kHz (Frequency Step) (9kHz)
Page 25
161(mm) Weight 3.7lbs(1.7kg) 3.7lbs(1.7kg) 1.7kg KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice. KENWOOD CORPORATION 14-6, Dogenzaka 1-chome, Shibuya-ku, Tokyo, 150-8501 Japan KENWOOD SERVICE CORPORATION KENWOOD ELECTRONICS ITALIA S.p.A. P.O. Box 22745, 2201 East Dominguez Street, Via G.