User Check List - Hoover HE332ALG User Manual

Wash the pre-motor filter using warm water [24] and allow it to dry [25] thoroughly
4.
before inserting it into the cleaner.
Cleaning the exhaust filter:
Unclip the exhaust filter cover and remove the exhaust filter pack. [22,23]
1.
Wash the exhaust filter under warm water [24] and allow it to dry [25] thoroughly
2.
before inserting it into the cleaner.
Remember: Do not use hot water or detergents. In the unlikely event of the
filters becoming damaged, fit a Genuine Hoover replacement.
Do not try and use the product without a dust bag or filter fitted.
Removing a blockage from the system
If the bag check indicator is red:
1. Check if the bag is full. If so, refer to 'Replacing The Dust Bag'.
2. If the bag is not full, then:
A. Do the filters need cleaning? If so, refer to 'Cleaning the Filter'.
B. Check if there is any other blockage in the system - Use a rod or a pole to
remove any blockage from telescopic tube or flexible hose.
WARNING: - The bag check indicator will remain red if the cleaner is used when the bag
is full, if there is a blockage or if the filters are dirty. If used for a significant period of time
with the bag check indicator red, an electronic cut out will switch the cleaner off to prevent
any risk of overheating. If this should happen, switch the cleaner off, unplug and correct
the fault (see 'Removing a blockage from the system'). It will take 30 minutes for the cut
out to automatically reset.
ACCESSORIES AND NOZZLES
All accessories can be fitted to the end of the hose handle [2] or to the end of the tube.
• 2in1 Tool combines several functions into one tool [K]:
- Crevice Tool – For corners and hard to reach areas.
- Dusting Brush – For bookshelves, frames, keyboards and other delicate areas.
• Pet Hair Remover Mini Turbo Nozzle* [X] – On stairs or for deep cleaning on textile
surfaces and other hard to clean areas. Particularly suitable for pet hair removal.
• Allergen Remover Mini Turbo Nozzle* [Y] – On stairs or for deep cleaning on textile
surfaces and other hard to clean areas. Particularly suitable for allergen removal.
• Parquet Nozzle* [Z] – For parquet floors and other delicate floors.
IMPORTANT: Do not use the Mini Turbo Nozzles on rugs with long fringes, animal hides
and carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is
rotating.

USER CHECK LIST

Should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
• Is the dust bag over-filled? Please refer to 'Cleaner Maintenance'.
• Is the Filter blocked? Please refer to 'Cleaner Maintenance'.
• Are the hose or nozzle blocked? Please refer to 'Removing a blockage from the
system'.
• A thermal cut out switches off the cleaner to prevent overheating if it is used when
full or there is a blockage or dirty filters. If this should happen: switch off, unplug
and correct the fault. It will take about 30 minutes for the cut out to automatically
reset.
IMPORTANT INFORMATION
HOOVER spares and Consumables
Always replace parts with genuine HOOVER spares. These are available from your local
HOOVER dealer or direct from Hoover. When ordering parts always quote your model number.
Quality
Hoover's factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.
Your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice.
3
*Certain Models Only ** Certain models only, nozzles may vary according to model
GB