User Check List - Hoover PRC18LI011 User Manual

Cleaning the dust container / multi-cyclonic separation unit
This cleaner uses a multi-cyclonic separation system, unique to Hoover. If necessary, the
separation unit can be disassembled from the dust container and cleaned:
1. Release the dust container from the cleaner pressing the bin release latch to detach
the dust container from the main cleaner and pull upwards to remove. [9]
2. Hold the dust container with one hand and with the other rotate the dust bin handle anti
clockwise to release it from the container. [11]
3. Remove the multi-cyclonic separation unit from the dust container pulling the handle.
[11]
4. If necessary, use a cloth to remove excessive dust from the multi-cyclonic unit surface. [12]
5. Reassemble the multi-cyclonic separation unit with the dust container and rotate it in
position. [13]
6. Refit the dust bin to the cleaner ensuring the hook has been positioned correctly in the
cleaner body. Then lock the container in place by pushing the handle down until the latch
connects with the main body of the cleaner: you will hear a click when fully connected. [14]
Removing a blockage from the system
1. Check if the dust container is full. If so, refer to "Emptying the dust container".
2. If the dust container is empty but suction is still low:
A. Do the filters need cleaning? If so, refer to "Cleaning the washable filters".
B. Check if there is any other blockage in the system. Use a rod or pole to remove
any blockage from the extension tube or flexible hose.
C. Check if pre-motor filter is fitted and filter cover is entirely closed.
D. Check if the dust container is fitted into place.
E. Check if the multi-cyclonic unit needs to be cleaned. Refer to "Cleaning the multi-
cyclonic unit".

USER CHECk lIST

should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
• Is the dust container over-filled? Please refer to "emptying the dust container".
• Is the filter blocked? Please refer to 'Cleaning the washable filters'.
• Check if the pre-motor filter is fitted correctly and filter cover is entirely closed.
• Check if the dust container is fitted into place.
• Check if the multi-cyclonic unit needs to be cleaned. Refer to "Cleaning the multi-
cyclonic unit".
• Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the system'.
*Certain Models Only **May vary according to models
• Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically
reset.
IMPORTANT INFORMATION
Hoover spare and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model number.
Hoover Service
Should you require service, spares and consumables at any time, please contact your
local Hoover Service Office.
Quality
Hoover's factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.
your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
subject to change without notice.
4
GB