Download Print this page
Hoover HW86-DPM-S User Manual
Hoover HW86-DPM-S User Manual

Hoover HW86-DPM-S User Manual

Dual power max

Advertisement

Dual
Power
Max
User Guide
HW86-DPM-S
Version 1.0

Advertisement

loading

Summary of Contents for Hoover HW86-DPM-S

  • Page 1 Dual Power User Guide HW86-DPM-S Version 1.0...
  • Page 2: Table Of Contents

    CONTENTS Contents Machine Overview General Safety Information Operation Maintenance FAQs Other Information...
  • Page 3: Machine Overview

    MACHINE OVERVIEW Unit Boost Trigger Handle Clean Water/Solution Tank Release Button Carry Handle Clean Water/Solution Tank Cap Clean Water/Solution Tank Dirty Water/Solution Tank Release Latch Dirty Water Tank Accessory Hose Connector Cover Hose and Solution Connection Port (Hidden) Nozzle Release Clip Dual Brushbars Nozzle Solution Trigger...
  • Page 4: General Safety Information

    6. Before using your carpet washer test your carpets/rugs/upholstery for colourfastness and pile distortion. 7. Only Hoover recommend tools and solution should be used with this carpet washer. Using other solutions may invalidate the guarantee.
  • Page 5: Operation 4 5 6

    • When using the carpet washer, basic safety precautions should always be observed and don’t over saturate your carpets. • Only use Hoover carpet solution. Using other solutions may cause excess foaming and will invalidate your guarantee. • The clean water tank should only be filled with warm water (max 40°C). Filling the clean water tank with hot/boiling water will damage your machine and invalidate the guarantee.
  • Page 6 OPERATION WARNING: Always unplug the carpet washer before performing any maintenance/troubleshooting checks. NOTE: Using more solution than recommended may cause excessive foaming. Filling the water/solution tank Press clean water/ Twist clean water/ Using the water/ Fill clean water/solution solution tank release solution tank cap solution tank cap, tank to ‘max fill’...
  • Page 7 OPERATION NOTE: Carpets should be dry vacuumed thoroughly before washing. Plug into mains, press the on/ Press the recline pedal and Squeeze solution trigger to off button to switch on. pull handle backwards. release solution and water mix. For best results apply water/ Press solution trigger together solution on the forward stroke with boost trigger to remove...
  • Page 8 OPERATION NOTE: The carpet washer should be in the upright position when using the hose, de-activating the dual brush bar. Using the wash tool Pull down accessory Push hose end and hose solution connector into Slide upholstery tool hose connector cover. hose and solution connection port.
  • Page 9: Maintenance 8

    MAINTENANCE IMPORTANT: Your dirty water tank is fitted with a float. When the dirty water tank is full, or the floor head is not in contact with the carpet the float will shut off the suction on the carpet washer. You will be able to hear if this has happened as the motor noise on the machine will increase.
  • Page 10 MAINTENANCE Removing and cleaning the nozzle Remove both tanks. From upright Lift nozzle release clip, pull Slide nozzle downwards position tilt carpet washer back. nozzle forward. to release from tabs. Rinse nozzle under Replace nozzle lining water to remove debris. up tabs.
  • Page 11: Replacing The Belt

    MAINTENANCE Replacing the belt Lie carpet washer on Use a crosshead Undo a further 3 Lift to remove side belt its back exposing brush screwdriver. Undo screws to the left cover. bars. 3 screws and remove off belt guard. belt guard. Remove 7 screws from Stand carpet washer Undo 2 screws and...
  • Page 12: Faqs

    FAQS Warning: To reduce the risk of personal injury, unplug the carpet washer before performing maintenance/troubleshooting checks. Why won’t my carpet washer turn on? • The plug may not be fully pushed into the electrical socket. • Check the fuse in the plug if this needs replacing, always replace with a 13amp fuse Why won’t the solution/clean water dispense? •...
  • Page 13: Other Information

    OTHER INFORMATION Service & Help If you have queries or concerns about using your Hoover, please visit www.hoover.ae Technical Specification Voltage: 220-240V ~50Hz Wattage: 1000W Cord length: 8m (approx) Weight: 8.9 kg (approx) Subject to technical change without notice. Consumables Ultra+ Carpet Cleaning Solution 1.5L...
  • Page 14 NOTES...