All manuals and user guides at all-guides.com
Reference
Troubleshooting
Symptom
• The power cord is disconnected.
No power
• The power of the external source
equipment is turned off.
No sound
• The speaker cable is connected to a
wrong position.
• An unplayable disc is inserted.
• The disc is placed upside down.
The unit does not
start playback
• The disc is not placed within the guide.
• The disc is dirty.
• The remote control is not pointed at the
remote sensor of the unit.
• The remote control is too far from the
The remote
unit.
control does not
• There is an obstacle in the path of the
work properly
remote control and the unit.
• The batteries in the remote control are
exhausted.
• Record protect tabs are removed.
Unable to record
About MP3/WMA
MP3/WMA Disc compatibility with this unit is
limited as follows:
1. Sampling Frequency
8 - 48kHz(MP3), 32 - 48kHz(WMA)
2. Bit rate
8 - 320kbps(MP3), 48 - 320kbps(WMA)
3. CD-R physical format should be "ISO 9660"
4. If you record MP3/WMA files using the soft-
ware which cannot create a FILE SYSTEM,
for example "Direct-CD" etc., it is impossible to
playback MP3 files. We recommend that you
use "Easy-CD Creator", which creates an ISO
9660 file system.
5. File names should be named using 30 letters
or less and must incorporate ".mp3",".wma"
extension e.g. "********.MP3" or "********.WMA"
6. Do not use special letters such as "/ : * ? " <
>"etc.
7. Even if the total number of files on the disc
has more than 1000, it will only be shown up
to 999.
Cause
• Plug the power cord into the wall outlet
securely.
• Switch on the external source equip-
ment.
• Set the speaker cable to the correct
position, then turn on the unit again by
pressing POWER.
• Insert a playable disc.
• Place the disc with the playback side
down.
• Place the disc on the disc tray correctly
inside the guide.
• Clean the disc.
• Point the remote control at the remote
sensor of the unit.
• Operate the remote control within about
23 ft (7 m).
• Remove the obstacle.
• Replace the batteries with new ones.
• Cover hols on back edge of tape with
tap.
About MULTI SESSION
- This function recognizes the multi session disc
according to a disc of CD-ROM type.
ex) If there are MP3/WMA files in the first ses-
sion, the MP3/WMA files in the first session
are only played. If there are only MP3/WMA
files in the whole session, all of the
MP3/WMA files in the session are played.
If there is an Audio CD in the first session,
only the Audio CD in the first session is
played.
Correction
13