D-Link DSL-2640U User Manual page 108

DSL-2640U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual
When the WPA, WPA2, or WPA/WPA2 mixed value is selected, the following settings are
displayed on the page:
Figure 85. The WPA2 value is selected from the Network authentication drop-down list.
Parameter
WPA2 Pre-
authentication
IP address RADIUS
server
RADIUS server port
RADIUS encryption key
Encryption type
Group key update
interval
When you have configured the parameters, click the APPLY button.
To edit the basic or additional wireless network, left-click the relevant line in the table. On the
opened page, change the needed parameters and click the APPLY button.
To remove the additional network, select the checkbox located to the left of the relevant line in the
table and click the DELETE button (
Move the switch to the right to activate preliminary authentication
(displayed only for the WPA2 and WPA/WPA2 mixed
authentication types).
The IP address of the RADIUS server.
A port of the RADIUS server.
The password which the router uses for communication with the
RADIUS server (the value of this parameter is specified in the
RADIUS server settings).
An encryption method: TKIP, AES, or TKIP+AES.
The time period (in seconds), at the end of which a new key for WPA
encryption is generated. When the value 0 is specified for this field,
the key is not renewed.
). Then click the APPLY button.
Page 108 of 174
Configuring via Web-based Interface
Description