Advertisement
w=
OPTIONAL CONFIGURATIONS
3. Find the section labeled Input Configure located behind the faceplate directly
in back of the KRELL Audio Video logo. The factory default setting is shown
in figure 1. Remove the jumper from the S-3 side and place it on the side
labeled proc as in figure 2.
4. Place the top cover back on the KAV-300i and insert the cover screws.
5. Plug the KAV-300i back into the AC outlet.
The KAV-300i is equipped with a pair of single-ended preamplifier outputs.
This allows the KAV-300i to act as a preamplifier when used with a separate
amplifier.
NOTE: The speaker outputs on the KAV-300i remain active at all times.
Advertisement
