Timing Analysis
The same format specification loaded for state analysis is also used for
timing analysis. To configure the logic analyzer for
timing
analysis:
....
Note
w
HP
103140
1. Move the State/Timing switch (Sl) on the preprocessor interface
board to the timing position (see figure 1-1, page 1-5).
2. Select the Configuration menu of the logic analyzer.
3. Select the Type field for the 80386DX analyzer and select Timing
(see figure 2-7) .
BS16 and RESET are not available for timing analysis.
BS16 appears on the format specification, but
is
not accurate for
timing
analysis because it
is
delayed by an edge-triggered latch on the
preprocessor interface board.
(EE) (
Run
Ane1yzer 2
Name;
Type•
Type• (
Off
Unassigned Pods
----------------
Pod 2
----------------
Pod 3
----------------
Pod 4
----------------
Pod S
----------------
Figure 2-7. Setting Machine 1 to Timing
80386DX Preprocessor Interface
Analyzing the Intel 80386DX
2-15