Table of Contents
Advertisement
_ Attaching the External
| | Attaching the EAC66U/V
| Antenna Connector
Band Separator/Mixer
(supplied)
(not supplied)
F;
-t
300 ohm twin
NEES
lead cable
300 ohm twin
bi
75 ohm coaxial cable
1 Loosen the screws on the antenna connector.
1 Loosen the screws on the U/V band
separator/mixer.
2 Fit the 300-ohm twin lead cable on the UHF antenna
under the screws on the antenna connector.
2 Fit the 300-ohm twin lead cable on the UHF antenna
under the screws.
3 Retighten the screws.
3 Connect the 75-ohm coaxial cable to the U/V band
separator/mixer.
4 Connect the U/V band separator/mixer to the
VHF/UHF IN plug on the VCR.
General Setup Information | 59
Advertisement
Table of Contents
