Assembly; Tools Required For Assembly; Contents Of Hardware Pack - Craftsman 917.293301 Owner's Manual

Your new tiller has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tiller
all parts and hardware you assemble must be tightened securely, Use the correct tools
as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(t) Utility knife
(t) Wire cutter
(1) Tire pressure gauge
(1) Screwdriver
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR'S POSITION
When right or left hand is mentioned in
this
manual,
it means when you are in
the operating position (standing behind
tiller handles).
FRONT
LEFT
RIGHT
OPERATOR'S
POSITION
i,iii i,, NIH '1'= . ................... I="
CONTENTS OF HARDWARE PACK
(2) Handle Locks
(2) Hairpin Clips
Extra Shear Pins & Clips
(1) Carriage Bolt
3/8-16 UNC x I Gr. 5
(1) Flat Washer
13/32 x 1 x 11 Ga.
(1) Center Locknut
3/8-16 UNC
(1) Cable Clip
(1) Pivot Bolt
3/8-16 UNC Grade 5
(1) Handle Lock Lever
5