Table of Contents
Advertisement
At the end of the season
1
Perform the fan operation for a half day.
Dry the inside of the unit.
2
Stop the unit and turn off the power supply.
The unit consumes approx. 2W even when the unit is not operating.
Turning off the power supply will help saving energy consumption and
cost.
3
Clean and reinstall the air filter.
4
Clean both the indoor and outdoor units.
5
Remove batteries from the remote control.
Proper installation
Suitable installation position
•
Do not put any obstruction in front of the indoor unit, preventing
proper ventilation and functioning.
•
Do not install the unit in any of the following places:
•
Where there is a danger of leaking flammable gases.
•
Where there is substantial splashing of oil.
•
Malfunctioning due to corrosion may occur if the unit is installed
in a spa where sulfide gases are generated, or in a seaside resort
exposed to sea breezes. Contact your dealer.
•
The air-conditioner and remote control must be at least 1 metre
away from a TV set or radio.
•
Drain the dehumidified liquid from the indoor unit into a spot that
drains well.
Inspection and maintenance
Depending on operating environment, the inside of the air-conditioner may become dirty after a few year operations. This will reduce performance.
In addition to normal cleaning, we would recommend inspection and maintenance. (This may lead the air-conditioner to having a longer life without
any trouble.)
•
Contact your dealer, or any distributor, for inspection and maintenance. (There will be a charge for this service).
•
We would recommend inspection and maintenance to be carried out during the off-season.
•
If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special
purpose tools are required.
Remote control handling
Replacing the batteries
The following cases signify exhausted batteries. Replace old batteries
with new ones.
•
Receiving beep is not emitted when a signal is transmitted.
•
Display fades away.
Pay attention to
the
marks
1
Pull out the cover and take out old batteries.
2
Insert new batteries. R03 (AAA, Micro) x2
3
Close the cover.
4
Press the ACL switch with the tip of a ballpoint pen.
The timer setting mode is displayed.
When the display shows any abnormal condition, Press the ACL
■
switch with the tip of a ballpoint pen.
RLC012A006A_EN.indb 8
and
Page 5
At the beginning of the season
1
Make sure that there are no obstacles blocking the
airflow around the air intake and outlet openings
of the indoor and outdoor units.
2
Check if there is no corrosion or rust on the base
frame of the outdoor unit.
3
Ensure that the earth wiring is not snapped nor
disconnected.
4
Ensure that the air filter are clean.
5
Turn on the power supply.
6
Insert batteries in the remote control.
Pay attention to operating noises!
•
When you install the unit, take care to choose a place that can
comfortably stand the weight of the unit and does not increase the
operating noise or vibration. If vibration is transmitted through the
house, fix the unit with the aid of vibration-proof pads between the
unit and the fittings.
•
Select a place where cold or hot air, operation noises from the
indoor and outdoor units do not cause any inconvenience to your
neighbours.
•
Do not leave any obstacles near the outlet and inlet of the outdoor
unit. This may cause malfunctioning and increased operating noise.
•
If you hear an irregular noise during operation, contact your dealer.
NOTE
•
Do not use old and new batteries together.
•
Remove the batteries when the remote control is not used for
a long period.
•
The recommended effective period of a battery conforming
to JIS or IEC should be 6 to 12 months with normal use. If
used longer, or when an unspecified battery is used, liquid
may leak from the battery, causing the remote control to
malfunction.
•
The recommended effective period is printed on the battery.
This may be shorter due to manufacturering time to the unit.
However, the battery may still be in working order after expiry
of its nominal life.
•
Do not go near high temperature places, such
as an electric carpet or stove.
•
Do not leave the remote control exposed to
direct sunlight or other strong lighting.
•
Do not drop the remote control. Handle with
care.
•
Do not put any obstructing obstacles between
WARNING
the remote control and the unit.
•
Do not spill any liquid on the remote control.
•
Do not place heavy objects on the remote
control, or step on it.
– 8 –
27/11/2556 9:21:35
Hide quick links:
Advertisement
Table of Contents
