To Set The Timer - Mitsubishi Heavy Industries SRK10YN-S7 User Manual

To set the TIMER

Current time setting
When inserting the batteries, the current time is automatically set to time setting mode.
■
13:00 is displayed as the current time. Set the clock to the right time.
Example: Set to 10:30.
1
Press the switch.
2
Press the or button.
3
Press the button.
NOTE
•
The timer operation works based on the time clock, so please set it correctly.
•
The remote control data is reset when the present time is set.
SLEEP TIMER operation
The unit stops automatically after the set time lapses.
■
Example: You prefer it to stop after 7 hours.
1
Press the button.
Every time the button is pressed,
the display changes as follows:
If it is pressed while the unit is off
SLEEP TIMER operation starts with the previous operation settings, and the air conditioning is turned off
after the set time elapses.
NOTE
•
When SLEEP TIMER is selected, the set temperature is automatically adjusted after a while, ensuring that the room is not too cold during
cooling.
During cooling : the preset temperature is lowered by 1°C at the start of SLEEP operation (when the timer is set). After that, the
temperature goes up by 1°C every an hour to become 1°C higher than the present temperature.
•
Cannot be set at the same time with OFF-TIMER.
OFF-TIMER operation
The unit stops automatically when the set time comes.
■
With the air conditioner turned off, start the operation from Step 1. With the air conditioner running, start
from Step 2.
Example: You prefer it to stop 22:30.
1
Press the button.
2
Press the button.
3
Press the or button.
Every time the button is pressed, the
display is switched in the order of:
Every time the button is pressed, the
display is switched in the order of:
4
Press the button.
NOTE
•
The unit stops at the end of the set period of time.
•
Make sure to press the button within 60 seconds from the last operation in step 3, otherwise the setting is not completed.
•
The current time is not displayed during OFF-TIMER operation.
•
Different from SLEEP TIMER operation, automatic set temperature adjustment is not done during OFF-TIMER operation.
RLC012A006A_EN.indb 5
Press with the tip of a ballpoint pen, etc.
The time display blinks and can be set to the current time.
(Set to 10:30)
The display changes from blinking to steady lighting and the setting is
complete. Make sure to press the button within 60 seconds from the last
operation in step 2, otherwise the time is not set.
Set to The timer light (yellow) is on.
No indication
(cancelled)
OFF TIMER display is blinking.
Set at 22:30.
...
0:00 0:10 0:20 1:00
0:00 23:50 23:40 ... 23:00 22:50 (Units of ten minutes)
The display changes from blinking to steady lighting and the setting is
complete.
The timer light (yellow) is on.
– 5 –
... (Units of one hour)
1:10 (Units of ten minutes)
27/11/2556 9:21:31