Name Of Each Part And Its Function - Mitsubishi Heavy Industries SRK10YN-S7 User Manual

Name of each part and its function

Indoor unit
Heat exchanger
Indoor unit fan
Operation point
•
Please stop the air conditioner when
adjusting the left/right air flow direction.
CAUTION
Remote control display
NOTE
•
Buzze r sound for remote control
When preset temperature 24°C, automatic operation and automatic airflow are selected, the buzzer sound (PiPi) is produced.
When turning off the air conditioner by pressing ON/OFF button (except CLEAN mode), the buzzer sound (Pi) is produced.
This function is useful for operating the air conditioner in the darkness.
Air flow setting
RLC012A016.indd
RLC012A006A_EN.indb 3
Air filter
Front panel
Up/down airflow direction
adjustment flap
Left/right airflow direction
adjustment louver
•
Adjust the direction by moving
the left/right louver by hand.
Remote control handling
Page 8
Outdoor unit
Unit display section
Remote control signal receiver
Unit ON/OFF button
RUN light (green)
•
TIMER light (yellow)
•
Temporary run operation
•
The unit ON/OFF button on the unit operates ON/OFF temporarily
when the remote control is not used.
Operation program
•
OPERATION MODE
•
FAN SPEED
• AIR FLOW
•
Operation starts by pressing the unit ON/OFF button; it stops if you
press the button again.
• Do not hold the Unit ON/OFF button down for more than 5 seconds.
(Holding it down longer than 5 seconds sets the automatic cooling
used during servicing or when relocating the air-conditioner.)
Air-conditioner operable temperature setting
•
Use within the following operational range. Operating outside of this
range may result in the protection devices being activated, preventing
the unit from working.
Outside temperature
Inside temperature
Inside humidity
Preset temperature
– 3 –
Air inlet
(On side & rear surface)
Air outlet
Outdoor unit fan
Heat exchanger
Illuminates during operation.
Illuminates during TIMER operation.
: AUTO
: AUTO
: AUTO
Cooling operation
Approximately 21 °C to 43 °C
Approximately 21 to 32 °C
Below approximately 80%
The long-term use of the unit with a
humidity level exceeding 80% may result in
condensation forming on the surface of the
indoor unit, leading to water drips.
27/11/2556 9:21:26