Operation - Genesis VS GMT16V Operator's Manual

To remove accessories from the tool, simply just reverse the above procedures
ACCESSORY ADAPTOR (FIG 3)
A universal accessory adaptor is included to allow use with
other brands' accessories. (Fein®, Bosch®, Dremel®, and
Rockwell®).
NOTE:
Fein is a registered trademark of C. &E Fein GmbH.
Bosch is a registered trademark of Robert Bosch GmbH.
Dremel is a registered trademark of Credo Technology Corp.
Rockwell is a registered trademark of Positec Group Limited.

OPERATION

WARNING:
follow all important safety warning and instructions before using this tool.
WARNING:
source before making any adjustments or setting up prior to cutting. Failure
to disconnect or unplug the tool may cause accidental starting, resulting in
serious personal injury.
SWITCH ACTION (FIG 4)
To start the oscillating tool, slide the ON/OFF switch
forward to ON position.
To stop the oscillating tool, slide the ON/OFF switch
backward to OFF position.
VARIABLE SPEED DIAL (FIG 5)
your oscillating tool has a variable speed control dial located
at the rear end of the tool. See FIG 5. you may select the
oscillating speed by rotating the control dial. Setting 6 is the
maximum speed (21,000 OPM) and setting 1 is the minimum
speed (15,000 OPM).
The variable speed control allows to set up a optimum
oscillating speed based on the accessory and the materials
being used on.
High oscillating speed recommended for: Sanding, Sawing,
Rasping wood or metals
Low oscillating speed recommended for: Scraping painting
wood or removing the caulk or adhesives.
To reduce the risk of serious personal injuries, read and
Always be sure the tool is disconnected from the power
ACCESSORY
ADAPTOR
FIG 3
OFF
ON
FIG 4
FIG 5
9