Table of Contents
Advertisement
Available languages
Available languages
Manual editing of messages
The program mode pushbutton (4) can be used to manually change the message sequence of trigger inputs 7 to 12
and the corresponding zone set-up. Manual editing is not possible for the trigger inputs 1 to 6; these input
configurations must be uploaded from the PC to avoid abuse.
Manual editing of trigger inputs is done as follows:
•
Press the program mode pushbutton (4) and keep it depressed for more than 3 s. The program mode indicator
LED (5) will light up to indicate that the message manager is in the program mode.
•
Briefly press one of the pushbuttons (9), e.g. #11. The corresponding trigger indicator LED (8) will flash and the
(upper) trigger indicator LEDs 1 to 6 will indicate the stored zones for pushbutton #11. The message indicator
LEDs (7) will only indicate the messages related to pushbutton #11. Their place in the sequence is not indicated.
•
Use the pushbuttons (9) to toggle the zones 1 to 6 ON and OFF, thus indicating the new zone selection.
•
Press the monitor pushbutton (3) briefly to clear the present message sequence for the selected pushbutton (9).
Pressing the monitor pushbutton (3) once more causes the message indicator LED #1 to flash; subsequent
pressing causes the message indicator LEDs #2, 3, 4, etc. to flash. If the monitor pushbutton is pressed for more
than 3 s the message indicator LED that flashed is selected as the first message of a new sequence for the
selected pushbutton (9). In this way up to four messages can be selected in a random order to be part of that
announcement. After the fourth message no more messages will be accepted.
•
Press the program mode pushbutton (4) once again for more than 3 s to enter the new configuration data and to
exit the program mode.
•
Repeat the above procedure for any of the other pushbuttons (9).
•
If during this manual editing process a trigger input is activated, the unit will quit the program mode and the
requested announcement will be started.
•
If in the program mode no pushbutton is pressed for approx. 25 s, the unit will automatically resume its normal
working mode, without storing the new configuration data.
37
MESSAGE MANAGER
Advertisement
Table of Contents
