Table of Contents
Advertisement
Maintenance and cleaning
2.Open the filter cover.
3.While some of our products are equipped with
an emergency water drain hose, some are not.
Follow the below procedures in order to drain
water.
If the product has an emergency water
draining hose, in order to drain the water:
a Pull away the emergency water draining hose
from its housing.
b Put the larger end of the hose into a large
vessel. Pull and remove the plug at the end
of the hose and drain the water into a vessel.
When the vessel is full, shut the nozzle of the
hose by inserting the plug into it. After you
empty the vessel, repeat above procedures and
drain the water inside the machine fully.
c When the water drainage is complete, block its
nozzle again with the plug and secure the hose
into its place.
d Turn and remove the pump filter.
43 / EN
Washing Machine /User's Manual
If the product does not have an emergency
water drain hose, in order to drain the water:
a. In order to collect the water to flow out of the
filter, place a large vessel in front of the filter.
b. Turn and loosen the pump filter until water
starts to flow (counterclockwise). Fill the flowing
water into the vessel which you put in front of
the filter. Always keep a piece of cloth handy to
absorb any spilled water.
c When the water in the machine ceases, turn the
pump filter and remove it fully.
Clean any residues inside the filter as well as
fibers, if any, around the pump impeller region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close
the filter cap by pressing on the tab. If it is one
piece, seat the tabs in the lower part into their
places first, and then press the upper part to
close.
43 / EN
Washing Machine /User's Manual
Advertisement
Table of Contents
