Bosch SH 87PW55N Series Operating Instructions Manual page 38

en-us Operating the Dishwasher
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete.
To save energy the recommended
setting is ˜:‹‚.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)
To change the setting:
Open the door.
1.
Press On/Off button (.
2.
Hold down function key # and
3.
press Start button P until the
display 8 shows •:‹x or š:‹x
(x can be any number).
Release both buttons.
4.
The indicator of function key #
flashes and the display 8
shows the factory set value.
Press function key # until the
5.
display 8 indicates ˜:‹x.
Press function key 3 until the
6.
display corresponds with your
requirements.
Press Start button P.
7.
38
Switching off the appliance
Short time after the end of the wash
cycle:
Open the door.
1.
Switch off On/Off button (.
2.
Turn off water supply.
3.
Remove the utensils when they
4.
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
Open the door.
1.
Switch off On/Off switch (.
2.
The LED's go out. The wash cycle
is saved.
To continue the wash cycle,
3.
switch on the On/Off switch (
again.
Close the door.
4.