MULTIQUIP G4100105 Operation And Parts Manual page 8

Lighting system
Hide thumbs Also See for G4100105:
Table of Contents

Advertisement

GENERATOR SAFETY
If using a generator to power lighting system,
refer to applicable generator manual safety
information section.
ELECTRICAL SAFETY
DANGER
„ Lighting system is equipped with a ground pin on the
power plug. For your protection, ALWAYS complete the
grounding path. NEVER insert the AC power plug into a
2-prong receptacle to operate lighting system.
When applying power to the lighting system, ALWAYS
connect the AC power plug to a 3-prong receptacle that
is grounded. The possibility exists of electrical shock,
electrocution and even death if the lighting system is
not grounded.
„ NEVER operate lighting
system or handle any
electrical equipment while
standing in water, while
barefoot, while hands are wet
or in the rain. A dangerous
electrical shock could occur,
causing severe bodily harm
or even death.
„ ALWAYS make sure the area
above the lighting system is
open and clear of overhead
power lines and other
obstructions. Contact with
overhead power lines or other
obstructions could result in
equipment damage, electrical
shock, electrocution and
even death.
PAGE 8 — GB43LED GLOBUG • OPERATION AND PARTS MANUAL — REV. #2 (10/28/21)
SAFETY INFORMATION
Power Cord/Cable Safety
DANGER
„ NEVER let power cords or cables lay in water.
„ NEVER use damaged or worn cables or cords. Inspect
for cuts in the insulation
„ NEVER grab or touch a live power
cord or cable with wet hands. The
possibility exists of electrical shock,
electrocution or death.
„ Make sure power cables are securely connected.
Incorrect connections may cause electrical shock and
damage to the lighting system.
NOTICE
„ ALWAYS make certain that proper power or extension
cord has been selected for the job. See Cable Selection
Chart in this manual.
LOADING AND UNLOADING
Cart Type - With Lifi ting Hook
If lighting system is equipped with a transport lifting hook,
refer to the following safety information.
CAUTION
„ Before lifting, make sure that lighting system parts are
not damaged and screws are not loosened or lost.
„ ALWAYS make sure crane or lifting device has been
properly secured to lifting hook of the equipment.
„ NEVER lift the equipment while lighting system is
running.
„ Make sure the mast is completely lowered before lifting
the lighting system.
„ Use adequate lifting cable (wire or rope) of suffi cient
strength.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gb43led

Table of Contents