MULTIQUIP G4100105 Operation And Parts Manual page 15

Figure 3 shows the location of the controls and components
for the GloBug GB43LED. The functions of each control is
described below:
1. Lamp— 300 Watt LED lamp that delivers 40,000 hour
service life.
2. Lamp Arm — Holds the lamp and allows it to be
individually twisted left to right and vice versa.
3. Adjust Lever — This lever allows the lamp to be
positioned up or down. Turn counterclockwise to
release lamp and position. Turn clockwise to tighten.
4. Main Power Switch-to-Lamp Power Cord —
Connects the lamps to the power (generator).
5. Mast — This mast is comprised of four separate stages.
The mast can be raised up to a maximum height of 17
feet (5.2 meters). When raising the mast, always be on
the lookout for overhead obstructions.
6. Mast Winch — Use this winch to raise and lower
the mast. Always be on the lookout for overhead
obstructions. Keep immediate area free of bystanders
and debris when raising the mast.
7. Winch Handle — Use this handle to adjust the mast
height.
8. Steering Handle — The GB43LED can be moved in
either a forward or reverse direction by pulling back or
pushing forward on the T-handle. In addition, the front
wheels are designed to turn in the opposite direction
of the T-handle placement thus allowing the unit to turn
either left or right.
9. Counterweight Lever — Holds the outriggers in place
when deployed.
10. Lamp Switches — Left switch turns upper lamps on
and off. Right switch turns lower lamps on and off.
11. Brake Pedal — Step on this pedal to apply the brakes.
To release the brakes, press down on brake pedal
again.
12. Tires — The GB43LED uses 4 pneumatic type tires.
Replace with only recommended type tire. NEVER
allow the rear tires to go flat. This could adversely affect
the braking system. Inflate tires to 35.5 psi (245 kPa).
13. Outriggers — ALWAYS deploy the outriggers when
raising the mast.
GB43LED GLOBUG • OPERATION AND PARTS MANUAL — REV. #2 (10/28/21) — PAGE 15
14. Brake Pad — When the brake pedal is pressed, this
pad will strike and hold the rear tires in place. Make
sure rear tires are inflated to the correct air pressure.
15. Catcher — Holds the outrigger in place in the stow
position.
16. Cart — Holds the generator that supplies power to
the lighting unit.
17. Locking Clamps — To secure the generator to the
GB43LED cart platform, place clamps (4) around the
pipe frame of the generator. Tighten securely to prevent
movement.
18. Generator Stopper — Holds the generator in place.
19. Lift Hanger — When lifting of the GB43LED is required,
always use a suitable lifting device of adequate lifting
capability. NEVER stand underneath the GB43LED
while it is being lifted.
20. Fold Lever — Holds the lamp stand in place after
adjusting its position.
21. Lamp Stand — Holds the four lamps and allows the
lamps to be positioned.
22. Main 120 VAC Power Cord (with molded NEMA5-15P
Plug) — This plug-end may be connected to a suitable
portable generator (11 amps at 120 VAC) or to an
established power source.
COMPONENTS