Daikin MC80ZVM Operational Manual page 21

MODE
Automatic airfl ow rate adjustment
FAN setting (Quiet, Low, Standard, High) is automatically adjusted according to the degree of air
impurity.
AUTO FAN
Purifying capacity increases as airfl ow rate rises.
If operating sound is a concern, airfl ow rate can be changed.
※ Maximum airfl ow rate during AUTO FAN MODE is High, which is lower than Turbo.
• Degree of air impurity corresponds to the volume of dust and the intensity of the odours in the
ambient air.
Saving energy
In power saving mode within ECONO MODE, the FAN setting automatically switches between
Quiet and Low only. Power consumption (※1) and operating sounds are minimised.
If the air is clean, after about 5 minutes, Monitoring mode automatically activates.
Recommended for use during sleep hours.
※1 By comparison to AUTO FAN MODE (approx. 20.8Wh), power consumption in ECONO MODE
(approx. 10.1Wh) is approx. 10.7Wh lower.
Test condition case in Malaysia: Operation in 12.4m² room over 1 hour. Assuming 1 cigarette was
smoked immediately after the unit was turned on.
Power saving mode
ECONO
FAN setting switches
automatically with an
airfl ow rate of Quiet or
Low.
• As the FAN setting is limited to Quiet and Low, air purifying capacity is reduced.
• Since the air in the room is not drawn in while the fan is stopped, the sensitivity of the PM2.5 sensor
and odour sensor will decrease. To prevent this reduction in sensitivity, turn Monitoring mode OFF.
►Page 25, 26
Reducing pollen levels
ANTI-POLLEN
A gentle air current is created by switching between the FAN setting between Standard and Low
every 5 minutes so that pollen can be drawn in and caught before it reaches the fl oor.
When you want to circulate the air in the room
The air in the room is kept clean and local variations in temperature are suppressed. It is even
more effective if the unit is installed opposite an air conditioner.
The airfl ow rate is High for about 30 minutes after operation start, in order to circulate the air in
CIRCULATOR
the room.
After that, temperature change around the unit is monitored and FAN setting is automatically
adjusted.
(There is no temperature adjustment function)
• If the indoor temperature is low, FAN setting may not be set to High.
(To reduce chills caused by airfl ow)
Usage and Function
If the air is clean, after
• The fan starts and stops periodically. Dust
about 5 minutes...
and odours are monitored.
• The following functions are turned OFF to
further reduce power consumption.
Streamer
If dust or odours are
Active Plasma Ion
detected...
Operation
►Page 25, 26
Monitoring mode
OFF
OFF
20