Setting Up The Battery Charger; Charging The Battery - Westfalia 93 19 71 Original Instructions Manual

Setting up the Battery Charger

(Battery and Charger not included)
1. If fitted, remove any battery from the battery charger.
2. Insert the battery charger mains plug into a suitable mains
socket.
Note: One LED on the charger will indicate ready status. For
further information please refer to the included manual of the
included charger.
WARNING: Only use this charger to charge compatible batteries
that are specifically designed for this tool.
WARNING: The charger is designed for indoor use only, and
must not be used in damp or wet conditions.

Charging the Battery

WARNING: Failure to follow the correct procedure when charg-
ing batteries will result in permanent damage.
Note: Normal charging time is 1 hour for a recently discharged
battery. However, if the battery has been left in a discharged
state for some time, it may take up to 1.5 hours to charge.
1. Slide a fully or partially discharged Battery onto the battery
charger.
2. Once charging commences, the red LED will illuminate.
3. When the battery is fully charged, the green LED will illumi-
nate.
If the Battery is defective the red LED flashes!
Note: Make sure the battery and battery charger are lined up
correctly. If the Battery does not slide onto the battery charger
easily, don't force it. Instead, remove the battery, check the top of
battery and the battery charger slot are clean and undamaged
and that the contacts are not bent.
Battery Charge Level: The battery has a built-in charge indica-
tor. Pressing on the (Test) button to the right will indicate the
charge level. The right LED indicates a high charge level and the
Operation
24