Belkin Bitronics AutoSwitch Kit User Manual page 12

P73121/F1U126-KIT/EU/man.qxd
B. Windows 3.x:
®
• Click on "File Transfer".
C. MS-DOS:
• At the command prompt, enter "SWPORT f".
You will see the LED of the port you are connected to on the Bitronics
AutoSwitch turn GREEN. This means that your computer is set to be in File
Transfer mode. However, you also need to set the other computer to File
Transfer mode before you can run your file transfer program. Hence, you must
repeat the above procedure on the other computer. When both LEDs are
green, you are all set to run your file transfer program. The cables and the
AutoSwitch acts like a parallel file transfer cable.
When you are done performing your file transfers, you can resume back to
normal autoswitching mode by pressing the RESET button on the AutoSwitch
or by clicking on "Multiple PCs sharing 1 device" in the Bitronics Software.
4/28/00 1:06 PM
Windows 95 / 98 and NT
®
8
Page 8
®