Connecting the IR control cable
The recorder sends commands to your connected set top box to control the channels of it through the IR control
cable. Make the following preparation.
1
Connect the plug of the supplied IR control cable to the CHANNEL CHANGE
IR jack on the recorder.
2
Place the transmitter near the set top box connected to the recorder.
After connecting, make the necessary setting (
When you use the recorder for the first time, also make the other settings (
Notes
• Do not connect an accessory other than the supplied IR control cable to the CHANNEL CHANGE IR jack.
• Do not cover the transmitter.
• The recorder sends commands even while it is turned off.
• Refer to the owner's manual of the connected set top box as well.
RF IN
(FROM ANT.)
R
L
VID
RF OUT
(TO TV)
CHANNEL
CHANGE
R
L
VID
VHF/UHF
IR
1
page 38).
Cable box / satellite system
2
Transmitter
Place as close as possible to the
signal sensor of the set top box.
page 28).
19