Connecting The Ir Control Cable - Toshiba RD-XS52SU Owner's Manual

Connecting the IR control cable

The recorder sends commands to your connected set top box to control the channels of it through the IR control
cable. Follow the instruction below.
1
Connect the plug of the supplied IR control cable to the CHANNEL CHANGE
IR jack on the recorder.
2
Place the transmitter near the set top box connected to the recorder.
DIGITAL AUDIO
Y P B P R
OUTPUT
BITSTREAM/PCM
COMPONENT OUTPUT
OPTICAL
R L VIDEO S-VIDEO
After connecting, make the necessary setting (
When you use the recorder for the first time, also make the other settings (
Notes
• Do not connect an accessory other than the supplied IR control cable to the CHANNEL CHANGE IR jack.
• Do not cover the transmitter.
• The recorder sends commands even while it is turned off.
• Refer to the owner's manual of the connected set top box as well.
HDMI OUTPUT
R L VIDEO S-VIDEO
INPUT1
OUTPUT INPUT3
R L VIDEO
S-VIDEO
1
CHANNEL
Cable box / satellite system
CHANGE
IR
(Keep the power on to receive
commands from the recorder.)
2
Place as close as possible to the
signal sensor of the set top box.
page 42).
Transmitter
page 34).
25