Connecting To Cable Tv Signal - Toshiba D-R2S Owner's Manual

Connections

Connecting to cable TV signal

Choose one of the below according to your usage of the cable box.
For watching received channels, connect to the TV via the audio/video cable.
OUT
16
RF IN
(FROM ANT.)
RF OUT
(TO TV)
CHANNEL
CHANGE
VHF / UHF
Incoming cable
RF IN
(FROM ANT.)
RF OUT
(TO TV)
VHF / UHF
Cable box
3CH
4CH
IN Incoming cable
RF IN
(FROM ANT.)
R L VIDEO
RF OUT
(TO TV)
CHANNEL
CHANGE
VHF / UHF IR R L VIDEO
Cable box
3CH
4CH
OUT IN
Incoming cable
This set-up will allow you to:
– record an unscrambled channel.
– record an unscrambled channel while watching
another (only when you connect a cable-compatible
R
TV).
IR R
You will need to:
• to record a channel while watching another, select a
desired channel on the TV (only when you connect a
cable-compatible TV).
This set-up will allow you to:
– record an unscrambled channel.
– record an unscrambled channel while watching
another (scrambled or unscrambled).
You will need to:
CHANNEL
CHANGE
I
• set TV channel to the output channel of the cable box.
• to record an unscrambled channel while watching a
scrambled channel, select a desired cable channel via
the cable box.
This set-up will allow you to:
– record any channels through the cable box.
You will need to:
• set "Cable Box/DBS" of "Set Top Box setting" to
"C.Box". page 37
S-VID
IN
• set "Select input" of "Set Top Box setting"to "3CH" or
"4CH". page 37
IN
• select a desired cable channel via the cable box.
S-VIDEO
• while the recorder is turned off, set TV channel to the
output channel of the cable box.
You can control cable channels from the recorder.
Preform the below.
1) Connect the supplied IR cable to the CHANNEL
CHANGE IR jack of the recorder.
2) Set "IR control" of "Set Top Box setting" to "On".
page 37
page 19