Daikin FTHF50VVMV Operation Manual page 29

Case
„ The unit does not receive
signals from remote
controller or has a limited
operating range.
„ Other electronic devices
start operating.
The flaps do not start swinging
immediately.
The air conditioner stops
generating airflow during
HEAT operation.
The HEAT operation stops
suddenly and a flowing sound
is heard.
Hot air does not flow out soon
after the start of HEAT operation.
The ON/OFF TIMER does not
operate according to the settings.
A sound is heard.
„ A sound like a flow of water
„ Blowing sound
„ Whistling sound
„ Ticking sound
„ Clicking sound during
operation or idle time
„ Clopping sound
Air does not come out.
The air conditioner continues
operating even after COOL or
DRY operation is stopped.
• Signal communication may be disabled if an electronic-
starter-type fluorescent lamp (such as inverter-type lamps) is
in the room. Consult your dealer if that is in this case.
• The remote controller may not function correctly if the
transmitter is exposed to direct sunlight.
• If the remote controller activates other electronic devices,
move them away or consult your dealer.
• The air conditioner is adjusting the flaps position.
• The flaps will start moving soon.
• Once the set temperature is reached, the airflow rate is
reduced and operation stopped in order to avoid generating
a cool airflow. Operation will resume automatically when the
indoor temperature falls.
• The outdoor unit is taking away the frost. The HEAT operation
starts after the frost on the outdoor unit is removed.
You should wait for about 4 to 12 minutes.
• The air conditioner is warming up. You should wait for 1 to 4
minutes. (The system is designed to start discharging air only
after it has reached a certain temperature.)
• Check if the ON/OFF TIMER correct. The actual length of timer
can be differ from user setted time for approx. 10 minutes.
• This sound is generated because the refrigerant in the air
conditioner is flowing.
• This is a pumping sound of the water in the air conditioner
and heard when the water is pumped out from the air
conditioner in cooling or drying operation.
• This sound is generated when the flow of the refrigerant in
the air conditioner is switched over.
• This sound is generated when refrigerant flows during
defrosting operation.
• This sound is generated when the size of the air conditioner
slightly expands or shrinks as a result of temperature changes.
• This sound is generated when the refrigerant control valves
or the electrical parts operate.
• This sound is heard from the inside of the air conditioner
when the exhaust fan is activated while the room doors are
closed. Open the window or turn off the exhaust fan.
„ In COOL or DRY mode
• If COOL/DRY operation is started with airflow settings on
"AUTO", the indoor unit will initially deodorise, which functions
to suppress any internal odours. As a result, the indoor unit
will not emit air immediately. (Wait for about 1 minute.)
• The air conditioner is operating in MOLD PROOF mode.
When you want to stop MOLD PROOF operation midway,
press .
Page 16
TROUBLESHOOTING
Explanation
27