Initializing The System; Ethernet Unit; Code Reader - Omron V460-H Series Network Connection Manual

8. Initializing the System

In this document, it is assumed that the Ethernet Unit and the code reader use the factory
default settings.
If you change their settings from the defaults, you may not be able to perform various setting
procedures as described.

8.1. Ethernet Unit

To initialize the Ethernet Unit, open the PLC I/O Table Window in the CX-Programmer. Then,
right-click on the Ethernet Unit 00 [1500] CJ1W-ETN21 and select Unit Setup from the menu
as described in step 2 of the procedure in 7.3.4. Editing Parameters.
The Edit Parameters Dialog Box is displayed. Click Set Defaults to proceed.

8.2. Code Reader

For information on initializing the code reader, please refer to How to initialize the settings? in
8-3 Q&A of the V460-H Industrial Handheld DPM Reader User Manual (Cat. No. Z461).
8. Initializing the System
31