Toastmaster TMDC24 Installation Operation & Maintenance page 11

I
nstallation
M D C
EDIUM UTY OUNTERLINE
Step 5: Adjust Air Shutters and Pilot Heights
All units are adjusted at the factory. However, burner air shutters and pilot heights should be checked at
installation and adjusted if necessary. On new installations, start with the burner of the unit(s) furthest from
the gas input to the manifold. This will purge the system of air.
1. Turn main gas supply "ON".
2. Follow the instructions on pages 12 to 13 light the pilots and burners.
3. If the burner flame is strong but lifting from the burner, loosen the screw on the air shutter and close
the shutter a little at a time until the flame settles back onto the burner.
Step 6: Condition Griddle Surface
For griddle and thermostatic-griddle models, the new griddle surface should be carefully tempered and
cared for in order to avoid possible damage. To break in a new griddle, first wipe it clean. Next, light all the
griddle burners and turn them to low for one hour. Then gradually bring each griddle up to frying tempera-
ture. Next, spread three or four ounces of beef suet, or as a substitute, baking soda, to season it. Never
allow water on a hot griddle and never wash it with soap and water.
Toastmaster
P 11
AGE
®